#
# 1-wire bus master configuration
#

menu "1-wire Bus Masters"

config W1_MASTER_MATROX
tristate "Matrox G400 transport layer for 1-wire"
depends on PCI
help
Say Y here if you want to communicate with your 1-wire devices
using Matrox's G400 GPIO pins.

This support is also available as a module. If so, the module
will be called matrox_w1.

config W1_MASTER_DS2490
tristate "DS2490 USB <-> W1 transport layer for 1-wire"
depends on USB
help
Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
for example DS9490*.

This support is also available as a module. If so, the module
will be called ds2490.

config W1_MASTER_DS2482
tristate "Maxim DS2482 I2C to 1-Wire bridge"
depends on I2C
help
If you say yes here you get support for the Maxim DS2482
I2C to 1-Wire bridge.

This driver can also be built as a module. If so, the module
will be called ds2482.

config W1_MASTER_MXC
tristate "Freescale MXC 1-wire busmaster"
depends on W1 && ARCH_MXC
help
Say Y here to enable MXC 1-wire host

config W1_MASTER_DS1WM
tristate "Maxim DS1WM 1-wire busmaster"
depends on W1
help
Say Y here to enable the DS1WM 1-wire driver, such as that
in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
hx4700.

config W1_MASTER_GPIO
tristate "GPIO 1-wire busmaster"
depends on GPIOLIB
help
Say Y here if you want to communicate with your 1-wire devices using
GPIO pins. This driver uses the GPIO API to control the wire.

This support is also available as a module. If so, the module
will be called w1-gpio.

config HDQ_MASTER_OMAP
tristate "OMAP HDQ driver"
depends on ARCH_OMAP
help
Say Y here if you want support for the 1-wire or HDQ Interface
on an OMAP processor.

endmenu