config PPC_MPC52xx
bool "52xx-based boards"
depends on 6xx
select PPC_CLOCK
select PPC_PCI_CHOICE

config PPC_MPC5200_SIMPLE
bool "Generic support for simple MPC5200 based boards"
depends on PPC_MPC52xx
select DEFAULT_UIMAGE
help
This option enables support for a simple MPC52xx based boards which
do not need a custom platform specific setup. Such boards are
supported assuming the following:

- GPIO pins are configured by the firmware,
- CDM configuration (clocking) is setup correctly by firmware,
- if the 'fsl,has-wdt' property is present in one of the
gpt nodes, then it is safe to use such gpt to reset the board,
- PCI is supported if enabled in the kernel configuration
and if there is a PCI bus node defined in the device tree.

Boards that are compatible with this generic platform support
are:
intercontrol,digsy-mtc
phytec,pcm030
phytec,pcm032
promess,motionpro
schindler,cm5200
tqc,tqm5200

config PPC_EFIKA
bool "bPlan Efika 5k2. MPC5200B based computer"
depends on PPC_MPC52xx
select PPC_RTAS
select RTAS_PROC
select PPC_NATIVE

config PPC_LITE5200
bool "Freescale Lite5200 Eval Board"
depends on PPC_MPC52xx
select DEFAULT_UIMAGE

config PPC_MEDIA5200
bool "Freescale Media5200 Eval Board"
depends on PPC_MPC52xx
select DEFAULT_UIMAGE

config PPC_MPC5200_BUGFIX
bool "MPC5200 (L25R) bugfix support"
depends on PPC_MPC52xx
help
Enable workarounds for original MPC5200 errata. This is not required
for MPC5200B based boards.

It is safe to say 'Y' here

config PPC_MPC5200_LPBFIFO
tristate "MPC5200 LocalPlus bus FIFO driver"
depends on PPC_MPC52xx && PPC_BESTCOMM
select PPC_BESTCOMM_GEN_BD