#ifndef _ASM_POWERPC_HEATHROW_H
#define _ASM_POWERPC_HEATHROW_H
#ifdef __KERNEL__
/*
* heathrow.h: definitions for using the "Heathrow" I/O controller chip.
*
* Grabbed from Open Firmware definitions on a PowerBook G3 Series
*
* Copyright (C) 1997 Paul Mackerras.
*/

/* Front light color on Yikes/B&W G3. 32 bits */
#define HEATHROW_FRONT_LIGHT 0x32 /* (set to 0 or 0xffffffff) */

/* Brightness/contrast (gossamer iMac ?). 8 bits */
#define HEATHROW_BRIGHTNESS_CNTL 0x32
#define HEATHROW_CONTRAST_CNTL 0x33

/* offset from ohare base for feature control register */
#define HEATHROW_MBCR 0x34 /* Media bay control */
#define HEATHROW_FCR 0x38 /* Feature control */
#define HEATHROW_AUX_CNTL_REG 0x3c /* Aux control */

/*
* Bits in feature control register.
* Bits postfixed with a _N are in inverse logic
*/
#define HRW_SCC_TRANS_EN_N 0x00000001 /* Also controls modem power */
#define HRW_BAY_POWER_N 0x00000002
#define HRW_BAY_PCI_ENABLE 0x00000004
#define HRW_BAY_IDE_ENABLE 0x00000008
#define HRW_BAY_FLOPPY_ENABLE 0x00000010
#define HRW_IDE0_ENABLE 0x00000020
#define HRW_IDE0_RESET_N 0x00000040
#define HRW_BAY_DEV_MASK 0x0000001c
#define HRW_BAY_RESET_N 0x00000080
#define HRW_IOBUS_ENABLE 0x00000100 /* Internal IDE ? */
#define HRW_SCC_ENABLE 0x00000200
#define HRW_MESH_ENABLE 0x00000400
#define HRW_SWIM_ENABLE 0x00000800
#define HRW_SOUND_POWER_N 0x00001000
#define HRW_SOUND_CLK_ENABLE 0x00002000
#define HRW_SCCA_IO 0x00004000
#define HRW_SCCB_IO 0x00008000
#define HRW_PORT_OR_DESK_VIA_N 0x00010000 /* This one is 0 on PowerBook */
#define HRW_PWM_MON_ID_N 0x00020000 /* ??? (0) */
#define HRW_HOOK_MB_CNT_N 0x00040000 /* ??? (0) */
#define HRW_SWIM_CLONE_FLOPPY 0x00080000 /* ??? (0) */
#define HRW_AUD_RUN22 0x00100000 /* ??? (1) */
#define HRW_SCSI_LINK_MODE 0x00200000 /* Read ??? (1) */
#define HRW_ARB_BYPASS 0x00400000 /* Disable internal PCI arbitrer */
#define HRW_IDE1_RESET_N 0x00800000 /* Media bay */
#define HRW_SLOW_SCC_PCLK 0x01000000 /* ??? (0) */
#define HRW_RESET_SCC 0x02000000
#define HRW_MFDC_CELL_ENABLE 0x04000000 /* ??? (0) */
#define HRW_USE_MFDC 0x08000000 /* ??? (0) */
#define HRW_BMAC_IO_ENABLE 0x60000000 /* two bits, not documented in OF */
#define HRW_BMAC_RESET 0x80000000 /* not documented in OF */

/* We OR those features at boot on desktop G3s */
#define HRW_DEFAULTS (HRW_SCCA_IO | HRW_SCCB_IO | HRW_SCC_ENABLE)

/* Looks like Heathrow has some sort of GPIOs as well... */
#define HRW_GPIO_MODEM_RESET 0x6d

#endif /* __KERNEL__ */
#endif /* _ASM_POWERPC_HEATHROW_H */